Click Image for Gallery
AIMIL Flame Photometer
Product Details:
- A solution of the salt is aspirated into the LPG-AIR flame. The vapour takes up energy from the flame and emits the wavelength characteristic colour of the element being tested.
- The intensity of emitted light is proportional to the concentration of the metal ion in the solution. This light is measured through a filter/detector/ amplifier combination. This being a comparator, known standard solutions are to be used for calibration. Compact Ease of Operation Mains Operated Large Bright LED Digital Display Rapid and accurate determination of Na, K, Ca & Li Compressor with Stable pressure output. Ordering Information
- AIM 049000 - Digital Dual Channel Flame Photometer with Sodium and Potassium filters and oil free diaphragm type compressor.
- AIM 040103 - Lithium Filter 12.7 mm dia
- AIM 040104 - Calcium Filter 12.7 mm dia
Specifications:
- Filters-Narrow band-pass interference filters for Sodium, Potassium, Calcium and Lithium available.
- Detector-Hermetically sealed Silicon Photo Detector
- Power Supply-Full IC Regulated Power supply to take care of mains variation of voltages between 200 to 250V
- Amplifier -Highly stable, High Gain all lC amplifier
- Display Large, Bright Seven Segment LED Panel meter to display 0-100 scale with negative and over range indication.
- Sensitivity- "Na" 4 ppm and "K" 2 ppm FSD Standard "Na" 2 ppm and "K" 1 ppm available at no extra cost on prior request
- Compressor- Oil free, diaphragm type with air reservoir. 90W motor, fuse protected complete with accessories. Stable pressure for mains fluctuations between 200V to 250V.
- Atomiser- Non-corroding, easily accessible and can be cleaned without putting out the flame.
- Sample Take-up-rate -5ml/min approximately
- Flame- LPG cylinder required with regulator (To be arranged by user)
- Nominal Input voltage- 220V, 50Hz Single Phase
- Dimensions-Flame Photometer 28X23X20cm Compressor 25.5 X20X23cm
- Gross Weight 20 Kg.Approx