DROP POINT

PENSKY MARTEN

This is widely used for determination for closed cup Flash Point of Fuel Oil, cut back asphalts, other viscous material and suspension of solids having a flash point above 490C (1200F).

General Description & Specification:
This apparatus is made as per IP 34. ASTM D-93 and IS 1209-1978 method B. The apparatus consists of brass test cup with handle, removable cup cover with spring operated rotating shutter having Oil Test Jet/Gas Test Jet Flame Device. Stirrer with flexible shaft. The assembly rests in air bath, which is covered, with dome shape metal top. The cup is fitted with insulated handle and locking arrangement near cup flange. The assembly is kept on round shaped electric heater with Energy regulator temperature control. Suitable for operation on 220 Volts 50 cycles AC .

Optional Accessories
The following accessories are not part of the standard supply and supplied at an extra cost.     

• Open clip for converting Close model to open cup test model as per IP 35. 
• IP 15C Low Range (-7-1100C x 0.50C) thermometer
• IP 16C High Range (900C – 3700C x 20C) thermometer
• Electric FHP motor with stirrer (in place of hand stirring)
• Voltage varrier temp. controller with digital temperature indicator.

COLD FILTER PLAGING POINT APP

DEMUSIBILITY TEST(WATER SEPARABILITY )

FREEZING POINT APPRATUS

GREASE WORKER

GUM CONTENT IN FUELS BY JET EVAPORATION

OXIDATION STABILITY TEST FOR DISTILLATE FUEL

OXIDATION STABILITY TEST

ROLL STABILITY OF LUBRICATION GREASE

PENETROMETER AUTOMETIC

PETROLIUEM DISTILATION

ROLL STABILITY OF LUBRICATION GREASE

ROLLING THIN FILM OVEN

ROTETING PRESSURE VESSEL OXIDATION TEST(RPVOT)

RUST PREVENTION TEST

SEQUENCE-IV-LIQUID-FOAMING-CHARACTERISTICS-APPARATUS

TAR VISCOMETER